您好, 歡迎來到化工儀器網
上海喬躍電子有限公司
溫度保險絲檢測恒溫槽/熔斷器檢測恒溫槽
熱熔器測試槽/熱熔器檢測恒溫槽
產品簡介
詳細介紹
測試方法：
測試方法：
將試樣兩引腳分別連接在測試設備的夾具上 通上10毫安左右的檢測電流（zui大不超過100毫安），將硅油池溫度先穩(wěn)定在TF-10度（硅油池帶攪拌，保證溫度均勻，升溫速率可調）然后將實驗放到硅油池內，采用受控溫度即0.5℃±0.2℃/MIN這樣的升溫速率，每個試樣都有溫度傳感器檢測溫度，有槽內有單獨測試通道，根熔斷器個測試通道，設計共10個通道，每個通道單獨監(jiān)控個熔斷器。熔斷器在某個溫度點熔斷后，設備及時提醒并鎖定熔斷溫度。
想了解多溫度保險絲檢測恒溫槽/ 熔斷器檢測恒溫槽資料請咨詢上海喬躍實業(yè)有限公司!
Test method:
Sample two pins are connected to the device under test fixture on the flux on 10 ma test current （not more than 100 ma）, silicone oil pool temperature stability in TF - first 10 degrees （silicone oil pool with stirring, ensure uniform temperature, heating rate is adjustable） then experiment on the silicone oil pool, the controlled temperature is 0.5 ℃ heating rate plus or minus 0.2 ℃ / MIN, every sample has a temperature sensor to detect temperature, slotted in separate test channel, a fuse a test channel, design a total of 10 channels, each channel individually monitor a fuse. After fuse fuse at a certain temperature, equipment timely warning and lock fusing temperature.
Want to learn more temperature fuse detecting thermostatic bath/fuse in constant temperature trough information consult Qiao Yue industrial co., LTD., Shanghai ephone: